Information in this article applies to:
Article ID: HXB1000 — Created: 1 Jan 2017 — Reviewed: 14 Jan 2019
How can I manually install configuration data for a particular uScope?
Early uScopes were shipped with a calibration file on a USB thumb drive. This file was copied to your PC when you initially launched the uScope Navigator application. In some cases, uScope Navigator could not identify the USB thumb drive and would prompt you to select the location of the configuration file.
The configuration file is located in the root folder of the thumb drive and has a file name similar to DEV-XXXXXXXX.ZIP. This ZIP file contains a compressed folder that contains the configuration and calibration data files.
In most cases, the automated installer will copy and install the configuration files automatically. However, there are some cases wher eyou may need to manually install these files.
When you re-start uScope Navigator 4, the new settings for the uScope should take effect.
uScopes shipped with uScope Navigator 4.3 and later do not include a separate configuration file. Instead, the configuration file is stored in the uScope memory and is copied directly from the uScope. If you have a uScope that was shipped with uScope Navigator 4.3 or later and you receive a prompt for the device configuration file, you may be experiencing communication problems with the uScope. In this case, verify that you are using a USB2 port on your PC.
Thanks for subscribing to this knowledge base article.
You will receive an email confirmation with a confirmation link. You must click the link to receive update notifications for this knowledge base article.
You are already subscribed to this knowledge base article.
It looks like you are already subscribed to this knowledge base article.