Support

uScope MXII Replacing the Illuminator LED
uScope MXII

Information in this article applies to:

  • uScopeMXII (All Models)

Article ID: MXB1243 — Created: 29 Mar 2019 — Reviewed: 29 Mar 2019

Question

If one of the illuminators on the uScopeMXII burns out, is it possible to replace it?

Answer

Yes. However, changing the illuminator requires factory re-alignment of the illuminator and re-calibration of the uScope. This is covered under the standard maintenance agreement for your uScope.

The LED is not a user-service item nor can it be replaced without re-aligning and re-calibrating the uScope.

We use LEDs that are designed with a typical life of 20,000 hours. You should be able to scan many thousands of slides with the supplied illuminator.

Rate This Article
Contact Microscopes International or speak with your local distributor.
Copyright © 2019 Microscopes International, LLC. All rights reserved.