Support

uScope Navigator (Browse) How to Apply Gamma Correction to Scanned Images
uScope Navigator (Browse)

Information in this article applies to:

  • uScope Navigator V4.0 and Later

Article ID: NBR1010 — Created: 1 Jan 2017 — Reviewed: 1 Sep 2017

Question

How do I apply gamma correction to my scanned images?

Answer

The Filter Manager allows you to create a sequence of filters you may apply to:

  • Images captured by the Overview Camera
  • Images captured by the Objective Camera
  • Fields used to create a Deep Zoom Image

One of the filters you can apply is the Gamma Correction filter.

  1. Click the Filter Manager in the uScope Navigator Side Bar.
  2. Create a new filter
  3. Select Overview, Objective, or Deep Zoom
  4. Add a new Filter
  5. Select Gamma
  6. Adjust the Gamma slider to your preference.

Note
The Objective Filter is used when browsing or scanning a slide. For best results, browse the slide and save two or three representative images. Then, in the Filter Manager, load them and compare the before and after images to view the effects of the filter sequence.

Related Articles

Rate This Article
Contact Microscopes International or speak with your local distributor.
Copyright © 2018 Microscopes International, LLC. All rights reserved.