Control Panel Changing Focus Options
Control Panel

Information in this article applies to:

  • uScope Navigator V4.5 and Later

Article ID: NCP1192 — Created: 18 Nov 2018 — Reviewed: 18 Nov 2018


In uScope Navigator v4.3 and earlier, changing focus options required that you enter Device Settings and make the selected changes. If you were in the midst of scanning a region of interest, you must abort the scan, enter the Device Settings dialog, and make the desired changes.


This effect is by design in uScope Navigator v4.3 and earlier.

Starting in uScope Navigator v4.5, changes to the user interface allow you to change the focus settings in a more natural, streamlined way. A new, slide-in panel displays and allows you to change focus settings when setting up to scan a region of interest.

Refer to the following articles for more information:

Rate This Article
Contact Microscopes International or speak with your local distributor.
Copyright © 2024 Microscopes International, LLC. All rights reserved.