Support

uScope Navigator (Control Panel) Fast Stack Focus Scan Settings
uScope Navigator (Control Panel)

Information in this article applies to:

  • uScope Navigator V4.5 and Later

Article ID: NCP1204 — Created: 14 May 2018 — Reviewed: 14 May 2018

Summary

Fast Stack Scan SettinguScope Navigator v4.5 introduces a streamlined method for changing the settings for the Fast Stack focus method.

Prior versions of uScope Navigator required that you change focus settings in the Device Options screen. Version 4.5 provides a more intuitive method of adjusting these settings.

Details

uScope Navigator v4.5 has a redesigned user interface that offers additional features and controls for scanning slides.

When selecting the region(s) of interest to scan, a new Focus Settings button allows you to alter the default settings for the selected focus method. You may change these parameters to suit your requirements.

  • Run — Steps
    The Run Steps specifies the number of steps to move the objective for each image in the focus stack. The number of steps is based on the objective magnification and NA.
  • Run — Range
    The Run Range specifies the range (above and below the initial focus point) to scan for best focus.

Refer to Fast Stack Focus Device Settings for more information about the Device Settings that are available.

Related Articles

Rate This Article
Contact Microscopes International or speak with your local distributor.
Copyright © 2018 Microscopes International, LLC. All rights reserved.