Support
Changing Focus Settings While Scanning
Control Panel
Information in this article applies to:
- uScope Navigator V4.5 and Later
Article ID: NCP1287 — Created: 28 Aug 2019 — Reviewed: 31 Oct 2020
Summary
In uScope Navigator v4.3 and earlier, focus settings could be changed only from the Device Settings dialog. If you were in the midst of defining a job, this was an inconvenience.
Starting in uScope Navigator v4.5, local Focus Settings Pop-up Dialogs are now part of the Scan Configuration Screen.
Details
The Scan Configuration Screen includes a Focus Settings button that opens a Focus Settings Pop-up Dialog where you may adjust the focus settings to suit your requirements.
Focus Settings are provided for the following focus methods:
Select the Focus Method...
The Focus Settings Pop-up Dialog is context-sensitive and only shows the settings associated with the selected focus method.
You must first make certain the desired focus method is selected from the drop-down menu.
Adjust the Focus Settings...
Click the Focus Settings button to open the Focus Settings pop-up.
The parameters are the same as those found in the Device Settings dialog.
Note
Changes you make in the Focus Settings Pop-up Dialogs become the new default focus settings for the associated focus method.
Related Articles
- Multi-Layer Scan Issues
Deep Zoom Images - Tips for Faster EDF Scans
Scan Mode - Tips for Scanning at 40X and Above
uScope MXII
Support Knowledge Base Control Panel Changing Focus Settings While Scanning