Support

Device Settings Saving/Restoring Device Configuration Files
Device Settings

Information in this article applies to:

  • uScope Navigator V4.0 and Later

Article ID: NDS1114 — Created: 2 Nov 2017 — Reviewed: 5 Mar 2019

QuestionLoad/Save Profile Buttons

How do I load a new device calibration file into the uScope?

Answer

When you open the Device Settings Panel, the following two buttons appear at the bottom of the panel:

  • Load Profile
    This button loads a device settings profile (PXM file) from disk.
  • Save As Profile
    This button saves the current device settings as a PXM file.

Load Profile Dialog These buttons do what you would expect. You may use them to save and restore the device options for the uScope.

Profiles are useful when you use specific focus or filter settings to scan certain types of slides or samples. Using a profile for each type of job/case/slide eliminates the time required to change device options.

When you load a profile, you are presented with a list of the PXM files saved to the device settings folder for the selected uScope. (Refer to Where are the uScope Calibration Files Saved? for more information about the device settings folders.)

Note

  • The PXM file is an XML file that contains the device settings for the uScope Navigator application.
  • Device settings profiles are stored in the Dev-XXXXXXXX device settings subfolder of C:\ProgramData\Microscopes International\uScopeNavigator4.
Rate This Article
Contact Microscopes International or speak with your local distributor.
Copyright © 2019 Microscopes International, LLC. All rights reserved.