Support

uScope Navigator (Install)

Manually Installing Drivers
uScope Navigator (Install)

Information in this article applies to:

  • uScope Navigator V4.0 and Later

Article ID: NIN1001 — Created: 1 Jan 2017 — Reviewed: 10 Mar 2018

Question

It seems that the uScope hardware drivers were not installed when I installed the uScope Navigator Software. What can I do to re-install the drivers without re-installing the entire uScope Navigator Application?

Answer

The uScope Navigator Application is installed in the following default folder:

  • C:\Program Files (x86)\Microscopes International\uScopeNavigator

After installation, the drivers (and other related files) required to control the uScope digital microscope are stored in the following folder:

  • C:\Program Files (x86)\Microscopes International\uScopeNavigator\Drivers

From this folder, run Setup.exe to install or re-install the uScope drivers.

Note
Drivers are included for Windows 7, Windows 8/8.1, and Windows 10. Driver files are signed and should work with any of these versions of the Windows Operating System.

Related Articles

Rate This Article
Contact Microscopes International or speak with your local distributor.
Copyright © 2018 Microscopes International, LLC. All rights reserved.