Scan Mode How to Apply Gamma Correction to Scanned Images
Scan Mode

Information in this article applies to:

  • uScope Navigator V4.0 and Later

Article ID: NSC1010 — Created: 1 Jan 2017 — Reviewed: 9 Aug 2019


How do I apply gamma correction to my scanned images?


The Filter Manager allows you to create a sequence of filters you may apply to:

  • Images captured by the Overview Camera
  • Images captured by the Objective Camera
  • Fields used to create a Deep Zoom Image

One of the filters you can apply is the Gamma Correction filter.

  1. Click the Filter Manager in the uScope Navigator Side Bar.
  2. Create a new filter
  3. Select Overview, Objective, or Deep Zoom
  4. Add a new Filter
  5. Select Gamma
  6. Adjust the Gamma slider to your preference.

The Objective Filter is used when browsing or scanning a slide. For best results, browse the slide and save two or three representative images. Then, in the Filter Manager, load them and compare the before and after images to view the effects of the filter sequence.

Rate This Article
Contact Microscopes International or speak with your local distributor.
Copyright © 2020 Microscopes International, LLC. All rights reserved.